Made of high-quality metal that is resistant to rust and wear, it can be used for a variety of tasks such as rough grinding high-speed steel drill bits, blade edging, fine grinding tungsten steel turning tools, polishing Bodhi roots, and so on.
There are seven different modes for adjusting the working speed.
The worktable’s angle can be adjusted freely, and the slave adjustment wheel adds a slot that can be moved up and down without popping up or popping out.
The sandbelt is 15mm wide at its widest point.
The no-load speed ranges from 4500 to 9000 RPM, and it produces little noise.
There are no instructions included in the package for this product. Perhaps other people who would use this are as savvy as I am, and perhaps I will as well after a while, but I am not an experienced user of any tool like this and would greatly appreciate some guidance. I’m not even sure where or how to put the belt on, and there’s some sort of extra bracket that came in the package that I’m not sure where it belongs. If I can figure it out and the device functions properly, I’ll update this review and post photos.
