Nailed it: This pneumatic 3-in-1 15.5-Gauge and 16-Gauge 2 tool is a great tool “It has 16 gauge T-cleats and L-cleats, as well as 15.5 gauge flooring staples. When you buy this tool, you get different base plates that can be used for both solid wood tongue and groove and engineered flooring from 1/2″ to 3/4″ thick.
An anodized aluminum magazine, no-mar plate, and self-leveling front foot make this nailer strong and easy to use. For solid wood tongue and groove flooring that is 1/2″ to 23/32” thick, this is the best tool for the job. A mallet with a fiberglass handle is included.
This is what you need. We want to make sure our customers get great value, great customer service, and long-lasting, high-quality products. For everything from roofing to siding to flooring, we make nailers and staplers that can be used for everything from nails and screws.
Tough and reliable: We make a wide range of construction tools and accessories that are built to last, like staplers and nailers for siding, flooring, framing, finish, and roofing. Compare our products to those made by Makita, Hitachi, Bostitch, Senco, Paslode, and Dewalt and see which ones are better.
The Freeman PDX50C Lightweight Pneumatic 3-in-1 15.5-Gauge and 16-Gauge 2-in-1 tool is very lightweight and can be used for many different things “For your hardwood flooring installation, the Flooring Nailer and Stapler is a great choice. It can be used with all types of solid tongue and groove hardwood flooring, like cherry, oak, maple, and walnut. These 16 gauge T-cleats and L-cleats can be used with this air powered flooring nailer and stapler. It can also be used with 15.5 gauge 1/2 inch nails and 15.5 gauge 1/4 inch nails “In this case, crown staples range in length from 1-1/2 inches to 2 inches for all three types of screws. Two different base plates let you work on flooring that is 1/2″ to 3/4” thick, and the no-mar design protects finished flooring from being scratched by the tool. This pneumatic tool is made of lightweight aluminum and steel parts that have been heat treated. It weighs 20% less than other pneumatic tools and is ideal for long-term use. An anodized aluminum magazine, a one piece drive blade, and high-quality rubber O-rings keep this 3-in-1 tool going for a very long time. The new design of this flooring nailer and stapler makes it great for both DIYers and professionals who build things because it gives you a lot of value for a lot less money than three separate tools would cost. The Lightweight Pneumatic 3-in-1 15.5-Gauge and 16-Gauge 2 is very easy to use “It comes with a long-reach fiberglass mallet with a padded grip, two interchangeable base plates, air tool oil, and other tools, and it’s covered by Freeman.
I got my package in a short time. Customer service on the phone was quick. It was a bad thing that I bought this gun, but I didn’t use it until after the 90-day warranty period was over. The firing pin broke, so it was too short to push a nail. In about 4 clips of nails, it broke. About 100 square feet of floor. No recourse.
Further, there are two locations that align to the edge of the board. If centered by weight and aligned to the stop it will fire nails right into the face of the flooring. One must be diligent to align it off balanced but with the arrows pointed to the edge. Even after being aware of this condition it is virtually impossible to go fast without making that mistake now and again.
