In this case, the Genmitsu CNC Router 3018-PROVer and the Laser Engraving Machine LE5040 are both compatible with this.
Control your CNC Router or Laser Engraving Machine without having to connect it to a computer first. You can move your CNC or Laser Engraving Machine where you want and run your projects without being tied down.
You can move each axis at the same time by holding down on the button. The upgraded offline controller can do this for a long time. In the past, you would have had to move the axis in small, fixed increments by putting the button down over and over again. Because it makes the job easier and saves you time, this helps.
You can easily turn your spindle on and off and set the Z-Axis tool setting with this tool. Do not put your project gcode on the SD card for these things. You don’t need it for these thing.
This upgraded offline controller now works better with gcode. It can even read some of the codes that aren’t standard, which means that it can avoid interruptions or misalignment when engraving.
My 3018 ProVer has a board with VGA ports, but this controller has a Pfostenstecker. I sent it back. There’s nothing I can say about how good things are.
