Our readers have shown us several ways of folding bandsaw blades, here’s one of them. Our readers have shown us several ways of folding bandsaw blades. By the time your hand makes three-quarters to one full revolution, the blade will have popped into three coils.
I must admit, when I know someone is watching that hasn’t seen me fold up a bandsaw blade before, I do it extra fast and super snappy to make it seem even more dazzling. I learned how to coil a bandsaw blade like this pre-YouTube and over the phone from the kids at Wood-Mizer, who supply and sharpen my blades. From there, whip the portion of the blade furthest from you towards the ground and just as the blade nears the ground give it a quick jerk up, with a snap.
This is our recommended method for folding a bandsaw blade. Hold the bottom of the loop against the floor with your foot and bring you right hand inside the blade and grasp the top of the loop firmly from underneath. Twist the blade by rotating your right hand so it creates 2 loops.
I know how to fold bandsaw blades, like the ones I had on my 14″ bandsaw, but the 201″ blade length on my FB710 makes for a huge diameter coil when I fold it the normal way. The guy at the bandsaw blade shop where I get blades made showed me a way to uncoil them gracefully but I didn’t try it myself in his shop and when I got home and tried it I obviously missed something! With larger blades with more spring power I have to use two hands so I use a different method: hold on either side maybe at 10 and 2-o’clock positions with my foot holding the bottom against the floor and bend the top of the blade towards me and down.
Notice my right hand is turned over, palm facing out, and the palm of my left hand is facing in. Rotate your right hand inward and around until the blade and your hands look like this, both palms facing in. 3) Make one more half rotation of your right hand, then bunch up the three loops so it looks like this.
how do you fold a bandsaw blade Related Question:
Can you flip a bandsaw blade inside out?
Just turn them inside out, it doesn’t make any difference. The only difference is what side they had up when they welded them. When I get blades from WM, they are ready to go on the mill.
Why won’t my bandsaw cut straight?
Band Saw: Why won’t my band saw cut straight? When the band saw cuts crooked, a dull blade, improper feeding, loose blade tension or not using a work piece guide could be the cause. Use the rip fence or miter gauge to guide the work piece uniformly through the cutting blade to make straight cuts.
What causes bandsaw blade drift?
Drift is cause because the blade buckles under the load. You can see that by stretching a ribbon between 2 points and applying a pressure to one of the edges, it will turn sideway easily. A sharp blade and high blade speed will help a lot with that.
Why do bandsaws wander?
If the wheels are worn and do not have a distinct top to the crown then the blade will not know where to go, and may wander around. This of course can cause poor cut quality and difficulty in setting the guides.
Which way do the teeth point on a bandsaw?
The blade teeth should be facing the operator and pointing down toward the saw table. Tension the blade just enough to take up the slack, then check the tracking by spinning the band wheels by hand.