My bandsaw blade has a back-and-forth motion. If the problem goes away, call the blade manufacturer or the retailer where you purchased the defective blade, and ask for a replacement. The blade on a saw left idle for long periods of time can leave an impression in the rubber tire which might cause erratic tracking.
how to fix my bandsaw Related Question:
Why is my bandsaw not working?
A bad power supply, broken power cord, failed on/off switch or bad drive motor can prevent the band saw from starting. Check the power supply first. Plug a shop light or other electrical tool into the electrical outlet that you’re using for the band saw to make sure the outlet works.
Why is my bandsaw blade stopping?
Using a dull blade or the incorrect type of blade can cause the band saw to cut through work pieces slowly. The blade will also move slowly through the work piece if the blade is installed incorrectly. A weak drive motor can also cause the band saw to cut slowly. First, check the installation of the band saw blade.
Why does my bandsaw wander?
The crown of the bandsaw wheels is what keeps the blade in place. The blade will always try to climb to the highest point of the wheel, the top of the crown. If the wheels are worn and do not have a distinct top to the crown then the blade will not know where to go, and may wander around.
How do you fix a bent bandsaw blade?
How to straighten a bandsaw blade? It is risky but if it’s absolutely necessary, a temporary fix to straighten a bandsaw blade can be done by placing it on an anvil and gently tapping it flat with a nylon head hammer/mallet or using a pair of gas pliers to straighten out the blade.
How do I get my bandsaw to cut straight?
Band Saw: Why won’t my band saw cut straight? When the band saw cuts crooked, a dull blade, improper feeding, loose blade tension or not using a work piece guide could be the cause. Use the rip fence or miter gauge to guide the work piece uniformly through the cutting blade to make straight cuts.
Why does my bandsaw keep jamming?
If there are too few teeth in the cut (teeth are too large), this will also lead to teeth stripping and cracks from the gullets. Not enough teeth also cause jamming and sometimes distortion to the product you are cutting, especially thin walled pipe.
Why does my bandsaw mill blade wander?
When you’re sawing a soft wood with hard knots, the engine will slow down each time you hit a knot. If the blade speed drops below about 5000 FPM, the blade will start to wander. The governor will kick in to get the engine back up to speed but by the time that happens you’re through the knot.
How tight should my bandsaw blade be?
The blade should deflect no more than 1/4 in. A good place to begin is to tension the blade until the meter reads proper tension for the next wider blade. For example, if you’re tensioning a 3/8-in.
What is a blade welder?
The T27555 Blade Welder can cut, weld, anneal, and grind bandsaw blades. This allows you to make new blades from bulk coils of band stock. Quickly rejoin a blade that has been purposely cut for making an internal contour cut. Repair broken blades that are still sharp and useful.