Changing sandpaper on a Black and Decker belt sander requires using the correct width for your sander. Slide the old sandpaper belt off the belt sander front and rear rollers. Look for the arrows on the inside of the new sandpaper belt and the arrow on the side of the belt sander.
Disconnect your black and decker sander from power source. Slowly turn sander over and let it rest on the handles with the sanding pad upward. Sheet sanders are designed to work with partial sheets of standard sandpaper, whereas random orbital sanders require round disks, typically attached to the sander base with either adhesive or hook-and-loop type fasteners.
Unplug the Black and Decker belt sander power cord from the wall outlet. Slide the old sandpaper belt off the belt sander front and rear rollers. Disconnect your black and decker sander from power source.
how to load a black and decker belt sander Related Question:
How do you release the tension on a Black and Decker belt sander?
Unplug the Black and Decker belt sander power cord from the wall outlet. Find the lever on the side of the belt sander below the body. Pull the lever forward to release the tension on the belt.
How much wood can a belt sander remove?
As mentioned earlier, abrasive belts can only remove a certain amount of stock dependent on grit size. With a three-head sander you can run a grit sequence of 100-150-180 and remove approximately 1/32 inch in one pass.
How much tension should a belt sander have?
Most wood sanding applications (such as mould sanding using narrow cloth belts) require a belt tension of approximately 40 psi. However, there are some special exceptions. For example, abrasive planing operations using coarse grits typically demand belt tension in the range of 70 to 90 psi.