how to load makita belt sander Related Question:
Which direction does the belt move on a belt sander?
Moving diagonally front to back and side to side will help average out the amount of cut that the belt is making. You do, however, have to actually set the sander on the workpiece, hold the handle, and pull the trigger. You do not have to push down on the sander.
How much wood can a belt sander remove?
As mentioned earlier, abrasive belts can only remove a certain amount of stock dependent on grit size. With a three-head sander you can run a grit sequence of 100-150-180 and remove approximately 1/32 inch in one pass.
How much tension should a belt sander have?
Most wood sanding applications (such as mould sanding using narrow cloth belts) require a belt tension of approximately 40 psi. However, there are some special exceptions. For example, abrasive planing operations using coarse grits typically demand belt tension in the range of 70 to 90 psi.
Why does my belt sander keep breaking belts?
Heat, humidity, and age can contribute to belt seam failures, but they’re not the only causes. Check that your belts are turning in the direction indicated on the inside face. When not using your sander, release the tension on the belt.
What determines the size of a portable belt sander?
Wrap it around the belt sander the same way you would put a belt on it. Cut the string so the ends meet up and then measure the string from end to end. To determine the width of the belt, you can measure the width of the roller or contact wheel the belt will run against.
Which sander is used to sand in corners and tight places?
The detail sander is specifically designed for the purpose of sanding corners and does an excellent job of reaching tight spaces. You can also sand by hand if you want using a wedge of wood and sandpaper.
What is used to Centre the belt on a belt sander?
The only adjustment you’ll probably have to make is “tracking” to keep the belt centered on the roller. Hold the sander up, turn it on, and see if the belt either rubs against the housing or starts working its way off the rollers. With the trigger on, adjust the tracking knob until the belt is centered on the rollers.
What is the best grit for sanding wood?
For heavy sanding and stripping, you need coarse sandpaper measuring 40 to 60 grit; for smoothing surfaces and removing small imperfections, choose 80 to 120 grit sandpaper. For finishing surfaces smoothly, use extra fine sandpaper with 360 to 400grit.