This is another video tutorial that gives you a thorough explanation of how to construct your bandsaw fence. The tutorial also comes with a few tips and tricks for your bandsaw fence to make it better. You would need to make notes as you go through the tutorial because there are some important points he makes regarding the design within the tutorial.
To put the fence on the right side of the blade, unscrew the fence from the clamp, turn it around and remount it. Tap the bit with a hammer through the hole in the bandsaw table to mark a pilot hole on the fence rail. For wider capacity, temporarily extend the fence’s rails by remounting them in a second set of holes.
By: John Doyle Resawing and ripping at the band saw has one set back – drift. To correct for blade drift, the angle of the band saw fence shown here can be adjusted. Slide the fence over the rails and tighten the clamps.
A good fence can make your band saw one of the most useful machines in your shop. This fence can be made in a weekend for around $20, and it will do a great job on your band saw. You can adapt this fence to any band saw, but the dimensions given here are for my 14″ Delta.
2×4″ extrusion 1×2″ extrusion 1×1″ extrusion 2×2″ corner brace 4″ linear bearing to fit 1010 extrusion 1-7/8″ linear bearing to fit 1010 extrusion 1/4-20 fixturing knob + 1/4-20 carriage bolt + 1″ spacer Linear bearing brake + bolt 1/4-20 specialty nuts & bolts Shim Stock………. If you order 80/20® stock off of Ebay, you don’t necessarily get the lengths you want. Align the holes in the extrusions with the screw heads and snug down the screws. Position the extrusions and braces then firm up two screws on each brace and check for square.
how to make bandsaw fence Related Question:
What is the fence on a bandsaw?
This fence adjusts both for blade drift and perpendicularity to the blade (essential when cutting thin veneers). In addition, the fence can be quickly changed to a low-profile position to allow the blade guides to be moved closer to the workpiece.
How high should a band saw table be?
For the small shop furniture maker, go with 14″ as the minimum for a bandsaw, though 16″ is better. Those doing larger work might even want 18″ or 20″ machines. Just make sure you have a minimum resaw height of 12″ for versatility.
What materials can a bandsaw cut?
Most bandsaws have two wheels rotating in the same plane, one of which is powered. The blade itself can come in a variety of sizes and tooth pitch (teeth per inch, or TPI) which enables the machine to be highly versatile and able to cut a wide variety of materials including wood, metal and plastic.
How thick can a band saw cut?
Band saws are the undisputed champ when it comes to cutting curves and slicing through thick material. Many small band saws can slice though lumber a full four inches thick, and bigger saws handle six-inch cuts.