how to start ferrex chainsaw Related Question:
Why is my electric chainsaw not starting?
Charge the chainsaw if it is not turning on. If it has a battery, the battery may be faulty and require replacement. If it won’t start even when the saw is plugged into a power source, the battery is not the likely culprit. Replace the fuse in the chainsaw if it is still not starting and the battery appears healthy.
What are the two methods of starting a chainsaw?
Because one of your hands must be pulling the starter cord rather than controlling the saw, there are really only two methods for safely starting a saw, the ground start or the leg-lock method.
How do you fix a chainsaw that won’t start?
The carburetor might need to be replaced. It could be damaged or old and no longer functioning. To test the carburetor, remove the air filter, pour a teaspoon of fuel into it, and pull the starter rope. If the engine starts momentarily and then dies, the carburetor is likely why the chainsaw won’t start.
Do electric chainsaws have spark plugs?
A spark plug is the component that provides the spark and is absolutely essential in gas-powered chainsaws. Other types of chainsaw such as electric or cordless (battery powered) don’t require fuel to run, therefore no spark plug is needed.
Do you start a chainsaw with the brake on or off?
The chain brake should be activated when you start the chainsaw. Many chainsaw models can be started in what is known as ‘half-throttle’ position. In this position, the chain can rotate – if the chain brake is not activated.
What is a choke on a chainsaw?
The choke position is the fourth setting on the master control lever. This setting is used to start the saw when its motor is cold. Stihl chainsaws denote the choke position using a nearly horizontal squiggle between two vertical lines at the lowest position on the master control lever.
Which position is choke on?
The choke is located before the throttle, and manages the total amount of air going into the engine. The choke is only used when starting a cold engine. When doing a cold start, the choke should be closed to limit the amount of air going in.
How long to wait if chainsaw is flooded?
Many people wonder if a flooded chainsaw will fix itself? The answer is yes, but not always. By letting the chainsaw sit for about 20 minutes it will allow some of the fuel inside the engine to evaporate.
What chainsaw is easiest to start?
The best gas-powered model, the ECHO 18 in. Gas 2-Stroke Cycle Chainsaw, is easy to start and has impressive cutting power.
Do all chainsaws take the same spark plug?
Spark plugs are a key part of maintaining a petrol power tool, especially STIHL chainsaws, and you may think that one spark plug is much the same as another. A standard NGK spark plug and NGK spark plugs sold by STIHL may have the same part number stamped on them, but the STIHL NGK spark plug has some key differences.
How do you start a high compression chainsaw?
A Measure of Pressure Unscrew the spark plug using a ratchet and screw the compression gauge in its place. Sometimes an adapter is needed to make a tight fit between the gauge and the chainsaw. Pull the starter rope a few times until the gauge stops moving. When it settles onto a number, you have an accurate reading.