how to set up makita belt sander Related Question:
How much tension should a belt sander have?
Most wood sanding applications (such as mould sanding using narrow cloth belts) require a belt tension of approximately 40 psi. However, there are some special exceptions. For example, abrasive planing operations using coarse grits typically demand belt tension in the range of 70 to 90 psi.
Where should the stock being sanded be held if the sanding disc rotates in a counterclockwise direction?
If the sanding disc rotates in a counterclockwise direction, position the material to be sanded from the center of the disc to the left edge. If positioned in this manner the sanding action will help to hold the stock down on the table.
Why does my belt sander keep breaking belts?
Heat, humidity, and age can contribute to belt seam failures, but they’re not the only causes. Check that your belts are turning in the direction indicated on the inside face. When not using your sander, release the tension on the belt.
What determines the size of a portable belt sander?
Wrap it around the belt sander the same way you would put a belt on it. Cut the string so the ends meet up and then measure the string from end to end. To determine the width of the belt, you can measure the width of the roller or contact wheel the belt will run against.
Why does the sandpaper keep falling off?
The reason sandpaper is coming off your sander is that the current sander pad is worn out, replace the pad to fix the problem. Orbital sander pads wear out from regular use, eventually, the hook and loop Velcro will not properly hold onto your sanding discs.