This instruction provides guidance to allow equitable enforcement of 29 CFR 1910.243(3) and 29 CFR 1926.304(f) as they pertain to the guarding of portable belt sanders. Portable belt sanding machines shall be provided with guarding on one side at the nip point where the sanding belt runs into a pulley,2. The standards presently in effect prescribe guarding requirements which essentially prevent flush sanding at corners, and important feature and an application of portable belt sanders.
belt sander osha regulation Related Question:
What are the safety rules for a belt sander?
Safety Rules Don’t wear loose clothing or gloves, keep long hair tied back. Never remove guards unless authorized by WRL Manager. Don’t place hands or fingers under pieces during feeding to avoid potential pinch hazard. Don’t let hands come too close to top of opening on sander.
Do belt sanders need guards?
The belt guards and motor cover need to be in place and need to be secure before starting the machine. The gap between the sanding belt and the table cannot exceed 1/8” 13 SAFETY PRECAUTIONS II ● Keep machine clear of Excessive dust. Dust is flammable and potentially explosive.
What are the 3 most important sander safety rules?
Safety Rules Dust mask advised. Don’t wear loose clothing or gloves, keep long hair tied back. Never adjust Sander or setup while Sander is running. Never remove guard unless authorized by Technician or WRL Manager • Setups requiring anything other than the standard sander equipment must be approved by supervisor.
What PPE is needed when using a belt sander?
What should you do to work safely with belt sanders? Wear safety glasses or goggles, or a face shield (with safety glasses or goggles). Wear a dust respirator for dusty operations. Make sure the sander is switched “OFF” before connecting the power supply.