High compatibility: the dust guard is compatible with the majority of 7-inch/180mm angle grinders. Angle grinders can be used to assemble the pieces on a variety of surfaces, including marble, concrete, tile, and walls.
Fresh air: When used in conjunction with a vacuum cleaner, it can help to reduce dust emissions and create a more comfortable working environment for you to work in.
Safe and straightforward. The angle grinder is locked with a push-pull catch, and the guard can be swiveled open for edge grinding at 90 degrees.
One Dust Shroud, eight Clamping Clamps, one Shroud Wrench, and one Universal Vacuum Cleaner Hose adapter are included.
There is no trace. To prevent dust leakage and secondary scratching of the surface, use a high-quality soft brush to clean the surface. If you have any questions or encounter any difficulties, please do not hesitate to contact us and we will assist you.
7-inch RED in siz.
KIPSTAL tooling accessories are designed to make your job easier and less time-consuming.
Angle grinders up to 7 inches/180mm in diameter will fit in this chuck. Angle grinders can be used to assemble the pieces on a variety of surfaces including marble, concrete, and tile.
It is compatible with the majority of vacuum cleaner equipment, resulting in a dust-free environment.
Secondary scratches can be effectively avoided with the use of high-quality brushes.
Packages.
one (1) dust shrou.
Clamping Set of 8 Pieces.
1 x Shroud Wrench, 1 x Shroud Wrenc.
1 x Hose Adapter for Vacuum Cleaners (Universal).
It didn’t fit any of my grinders, including DeWalt, Milwaukee, Makita, and DeWalt 60volt and 20volt models.
This will most likely fit small grinders, but it did not fit any of the ones I own. Because the profile is too steep, the wheel is prevented from touching the floor; adding a washer on the back did not help because it was too far above the arbor thread; the height is fixed: any other shroud that I own (Makita, dustless industries) has at least 1/4″ room; I adjust the wheel to brush level and when you put it on the surface, it has room to push the wheel down; on this one, you will most likely need to smash the brushes to make the wheel lower to touch the grindin.
It looks like good quality plastic, and I liked the look of it. I tried it on all of the grinders that I own, but quickly realized that it was not going to be good enough for me, so I returned it and ordered two Makita grinders at the same time.
