The GA Pin Nailer is great for attaching all types of trim and molding without splitting the wood, and it’s very easy to use. The tool has a lightweight, narrow body that is easy to hold and adjust the dial on the magazine of screws.
The brad nailer has a 100-brad magazine and a simple dial that lets you set the depth. Fires 23 gauge pins from 1/2″ to 1″ in length.
All-metal aluminum construction makes the tool lightweight and durable, and the rubber grip is ergonomic and comfortable.
All kinds of precision trim work can be done with a precise fastener that drives pins. These pins can be used for everything from small picture frames to jewelry cases to molding.
Reversible belt hook and trigger with a safety mechanism that stops the gun from firing when it’s not supposed to.
If there is a problem with the product, Lakidur will send you a new one for 18 months.
Welcome to the official Lakidur store. We have an 18-month warranty for any problems with the quality of our products.
We want to make sure our customers get the best value, the best customer service, and long-lasting, high-quality hardware tools.
People who work with things.
Connected to air and a wind pipe, it can work when its pressure gets to 0.35MPa, which means it can move when its pressure gets that hig. Before you change the length of the tacks, you should pull out the rest and drag out the regulator. It is important to lubricate the machine before it is used every day, so please do that before you start. It’s time to clean the tacker and get rid of all the rest after the surgery.
Attention.
1. Make sure you read all of the operating instructions before you start.
2. Any gas that can be flammable or explode, like Oxygen, is not allowed. One way to get the job done is to use compressed air. The pressure of the air must be less than 0.8MPa.
3. Remove the air connector when you are installing tacks. During this time, don’t press the trigger at all. Not at anyone else or yourself.
4. Don’t hammer, break, or use it with no. This will damage it.
A good 23 gauge micro pinner can shoot pins with heads that are between 1/4″ and 1″ in length. Has a nice knob on the side that makes it easy to change the magazine for different sized nails. The nailer’s driver is very well made. It only leaves a hole the size of the nail in the wood. It comes in a case with a new piston driver and some oil inside. It’s hard to believe that for this price, I’ve run about 1000 nails so far with no problems.
