Use your tailstock to center plastic over faceplate by using the center impression against your live center. Once my faceplate was sitting flush against the bandsaw table I knew it was seated just right. There’s a small indent in the table that would keep the insert from spinning I heated up a small nail to stick into the plastic edge.
“Of course, my table inserts is just a bit smaller than 2 1/2/”. “I measured it as 2 31/64”. I would say that I would cut them on my band saw and them sand it smooth, but……. “I have a 16” delta scroll saw. 02-16-2010, 7:12 PM #2 I have been thinking that I will try to make at least one good circular template that fits my table and then route a bunch of inserts.
Shipping & Returns Learn more about policies and international shipping. Learn More Customer Care Talk to a friendly customer care representative to help with your purchase. 1-800-225-1153 Talk to an Expert Get advice on the latest products and help with your projects.
Band saw inserts will inevitably get messed up over time. Get an inexpensive set of 3 replacement inserts and get back to work. Semi-rigid plastic or acrylic material *Will not hurt blade’s teeth.
make bandsaw table insert Related Question:
What is the slot for on a bandsaw table?
The support pin keeps the two sides of the table rigid and on the same plane. Left unsupported, the table can rack unevenly as heavy pieces move across it.
Can you use a miter gauge on a bandsaw?
Description. This miter gauge is for use with our Rikon 10″ benchtop bandsaw. It has a protractor head that angles 60° to the left or right, and is graduated in 1° increments.