You can use it with a drill or an impact driver that you already ow.
Easy to cut backer board and Fiber Cement Siding Planks with little dust.
For the best tool clearance and material flow, the head can rotate 360 degrees.
A person who can cut very precise arcs, straight lines, and small amounts of materia.
Made in the United State.
The telescoping drill clamp fits drills and impact drivers of all sizes, even those with lithium-ion batteries. The tool can now rotate 360 degrees and lock into place after a recent redesign. The adjustment wrench now goes with the tool, so it can’t be lost. This way, the tool can’t be stolen. The drive shaft has a hex shank that fits into the chuck of any drill or impact driver. Half of the cuts made by the TSF2 are made by the TSF2 “a backer board that is 13 mm thick. It can also cut a piece of 5/16” fiber cement siding. Straight cuts and arcs with the ability to go around curves for window and door arcs can be made with this. The blades are made of high carbon steel that has been treated. They also have a reversible skid plate to make sure they last a long time. Replacement blade and skid plate for TSF2RB are here.
Not only have I worked with hardie backer and hardie siding, but I’ve also worked with a lot of hardie backer and hardie siding. Score and snap doesn’t work for me unless I use the 1/4 method stuff. The Hitachi Hardi saw blade was my go-to, but it makes a lot of dust, which is bad for your health, so I changed it. You had to wear a respirator and goggles when you were cutting with the saw blade, so you di.
Pro.
For the price of two hardie blades, you can turn your drill into a pair of shears.
* They cut quickly and can be used to shape and cut in a certain direction.
* You can make a fairly straight cut by putting chalk on the ground.
* There is little dust. To protect myself, I wear an NIOSH dust mask and safety glasses (as opposed to a respirator and goggles when using the saw blade).
In addition, I’ll even cut inside the work area instead of outside and bring it in. I use a vacuum with a HEPA filter when I cut to clean up the mess.
In many Malco products, you can order replacement parts for the parts that wear out, just like you can with other products from this company.
CON.
It gets a little heavy at the end, so if you work with this for a living, you might want to get a “dedicated” pair of shears.
* It took a while to figure out how to make this work with my drill. So I wouldn’t take it off and on. For real drilling, keep a second tool on hand at all times.
