From 1-1/4 inches to 15-gauge nails. Up to 2-1/2-inche. In terms of length.
Ideal for installing crown and base moldings, window and door casings as well as chair rails as well as cabinets and exterior trim and stairs.
It’s easy to switch between sequential or contact nailing with a simple flick of the switch.
Tool-free depth of drive dial adjusts for flush fastening into different materials for better control and a more professional finish.
Lightweight: This finish nailer weighs only 4.2 pounds, which reduces user fatigue and makes it easier to move around.
As you adjust the exhaust port, it can be turned 360 degrees to direct air away from you or your work piece.
When you need to put in crown and base moldings, window and door casing and chair rails, cabinets and exterior trim as well as stairs, you should use the NT65MA4 15-Gauge Angled Finish Nailer to do it. The NT65MA4 nailer has a small body and an angled magazine that make it easier to work in tight places. Work gets done faster and cleaner thanks to an air duster that comes with the tool. From 1-1/4″ to 2-1/2″ in length, the NT65MA4 can hold nails with a 15-gauge that are long enough.
Over 3,000 nails have been driven into the ceiling, and I can’t imagine using a hammer to do this work at all. This Metabo HPT Finish Nailer is easy to use, light enough to use all day, and has always worked. If I run the nail gun at 90 pounds, I use 23/32″ pine tongue and groove car siding, and the nails set a little below the surface. Definitely worth it.
