Buy Milwaukee 2811-20 M18 FUEL 18-Volt Brushless Cordless GEN 2 SUPER HAWG 7/16 in. Right Angle Drill Milwaukee 2811-20 M18 FUEL 18-Volt Brushless Cordless GEN 2 SUPER HAWG 7/16 in. Right Angle Drill (Tool-Only)

This is a Milwaukee 2811-20 M18 FUEL 18-volt battery-powered drill. It’s a right angle drill with a 7/16 in. drill bit (Tool-Only.

With the power and speed to replace corded right angle drills, the new MILWAUKE M18 FUEL SUPER HAWG Right Angle Drill with QUIK-LOK is the best tool for the job. On an M18 REDLITHIUM HIGH OUTPUT 6.0Ah battery, the right angle drill can make up to 100 2-9/16 in. holes through 6 in. beams per battery charge. This means that users can drill up to 100 2-9/16 in. holes through 6 in. beams per battery charge (not included). The Milwaukee SUPER HAWG has a POWERSTATE Brushless Motor, better REDLINK PLUS electronics, and REDLITHIUM HIGH OUTPUT Batteries that power it. The drill’s QUIK-LOK chuck is made of all metal, so it is very strong and long-lasting. You can also use the QUIK-LOK chuck with one hand to quickly insert and remove attachments. A tool with an all-metal side handle and an LED light gives users the best control and visibility while they work with it. The M18 FUEL SUPER HAWG has enough power and run-time to finish a single-family home’s rough-in or rough in multiple multi-family units on a single charge. In slow speed, a mechanical clutch can be used to stop the car. This is QUIK-LOK. Under heavy load, the POWERSTATE brushless motor can keep up with the 6-1/4 in. holes. Maximum performance is ensured thanks to REDLINK PLUS intelligence. It also protects against overloads and overheating, as well as over-discharge. All metal on the side handle for the best control. LED lights are used to light up the work area. It works with all M18 batteries. M18 FUEL SUPER HAWG and a side handl.

Used to make holes for pipes that were 2″, 3″, or 4 inches long. There were no burrs or burrs that made the hole look bad. Quick and simple. Good thing to do.

Leave a Reply

Your email address will not be published. Required fields are marked *