Double head, adjustable dept.
1/4 “air inlet with a metal filter to keep foreign objects from getting in.
Right angle quick cutting and filleting with a small body make this tool easy to use and easy to find.
A low-profile throttle lever with an ergonomic grip.
Make sure to set the air intake to the fifth gear. The air intake can be freely adjusted.
Specification.
Chamfering range: c 0.1-c0..
Intake pressure is 90Psi, o.
The weight: 0.42k.
Speed: 22000rpm with no loa.
Deep enough to turn around: 0.1mm up to 0.09mm.
Size of the chamfer: 8m.
1 / 4: Intake connection 1 / .
It must be at least 3mm thick.
The smallest chamfer diameter is 7mm.
The opening with the smallest depth: 5 m.
Is shown in the figure.
Note.
If you don’t know if something is compatible or fits, please send us a message. We’ll get back to you through customer service as soon as possible.
Good tool, but it needs at least 90 psi and a lot of air flow to work. I don’t think a small portable compressor would be able to keep up with it. The 1/4 inch standard fitting isn’t very good, but there are a lot of better fittings that are easy to find. There are a lot of places to get standard triangular carbide cutters that can be bought from. Also, the pilot ball bearing is a standard size and replacements for it are cheap. The chips it throws are very sharp, so protective clothes and eyewear are very important. In my mind, I thought it was going to be very loud. It wasn’t that bad at all. Making it easier to control the tool if the air line is held up by something like a shoulder strap or thrown over your shoulder. Worth the money.
