Ships from the United States in a hurry and is brand new.
It’s made of carbid.
Long Reach Double Cut Rotary Burr Set with 4 pieces.
For high-performance engine work, this is the best thing.
1/8″ Shank, about 6″ Lengt.
There are a lot of materials that can be made, like cast iron and cast steel. There are also materials that can’t be made: ceramic tile, marble, bone, and other non-metallic materials.
High efficiency, a high-quality finish, a long service life, and a good return on investment.
It’s safe and easy to use, and it can cut down on the amount of work you do.
Processing of mechanical parts such as chamfering, rounding, and groove.
Dual Chamber has lines that cross over each other, making it hard to block the lines. It’s better for objects that aren’t very dense.
1 piece of cylinder with a ball at the en. It is 3/8″ x 3/4.
It’s one ball shape 3/8.
One piece of tapered cone end is 3/4″ x 3/8″ and it comes with 1 piece.
There is 1 piece of tapered cone end that is 1″ – 1/2″ long.
A package comes with.
4pcs Carbide rotary tools in a se.
I used this to replace a hinge pin on the door of my car with a new one. Long enough not to hit other metal parts. I usually use carbide bits to cut off parts of cars that are hard to get off and let the stress of the metal fall away. When I couldn’t move my pitman arm, I ground off the metal until it was near the teeth. Easy after that. One of the best ways to do this is with an oxy/acetylene torch, which can be used to do this on metal parts, but not on rubber parts. In every toolbox, next to your drill bits, you should have this.
