Working table 6330 is small and multifunctional. The table is good for mini drills and drill brackets. It can also be used with other machines that are good enough.
The work table is made up of several adjustable aluminum alloy dovetail slots that can make sure there isn’t a lot of wasted space and that the work is done correctly.
This table is 330 by 95mm.
190mm in the X direction. It takes 65 mm to move in the direction of Y. Between the grooves: 34m.
Hand wheel with a scale: A ring is 1.5mm.
I bought this because I thought I could do some simple drill press milling with it. I didn’t have high standards for NASA quality. I looked at the reviews and decided to order one after I thought about it. Because I was working on something else, it didn’t get any attention for about 6 weeks. It was a big mistake. Get it out today and play with it a little. I put the knobs on and put the press on. In the press, I put one of my new 4mm end mill bits in. I put a 1/2×13 standard #3 nut on the carriage so I can make a.0001 cut. The top carriage moved so much on the bottom carriage that the new bit broke a tooth. I switched to a 6mm bit and tried again. I didn’t break the bit, but after about 1/16th of an inch into the cut, I just stopped. I think I have Chinese paper because I didn’t try this thing for too long. Don’t do what I did.
