One 1.5KW Spindle Motor, one 1.5KW/110V HY Inverter, one 3.2M Water Pump, one 5M Water Pipe, one 65mm Spindle Clamp, 13 x ER11 Collets, and one 65mm Spindle Clamp (1,1.5,2,2.5,3,3.5,4,4.5,5,5.5,6,6.5,7mm).
Only 0.005mm will run out. Speed:0-24000rpm, inverters, DC/AC inverters, and frequency: 0-400Hz.
Er11 Collet Set Gripping Range: 1-inch to 7-inch long (1mm,1.5mm,2mm,2.5mm,3mm,3.5mm,4mm,4.5mm,5mm,5.5mm,6mm,6.5mm,7mm.
The spindle motor is used in Lathes, Mills, Car Hoists, Pumps, and Conveyors, among other things.
We will help you get your money back if you have any problems.
110V 1.5KW Water Cooled Spindle Motor CNC Spindle Motor 65MM Clamp Mount +13PCS ER11 Collet +1.5KW 110V Inverter + 5M Water Pipe +110v Water Pump for CNC Route.
Feature.
A water cooled spindle is the first thin.
Size:65m.
Power:1.5K.
Voltage:110.
Frequency:0-400H.
Speed:0-24000rp.
It is used for water cooling.
less than 0.005m.
Gripping with greas.
2. The inverte.
HY Inverter is a brand name.
Type:1.5KW/110.
The tech parameters.
It takes 110V to start. It has a voltage of 110VAC.
This is the frequency range for the input: 48-63 H.
Output Frequency: 0 to 400 kHz.
3 phase or 1 phas.
Output: 3 phas.
One to seven millimeters is the range of grips (1mm,1.5mm,2mm,2.5mm,3mm,3.5mm,4mm,4.5mm,5mm,5.5mm,6mm,6.5mm,7mm.
Tolerance for run-out is 0.01mm (0.0006″.
Packages come with.
1×1.5KW Spindle Moto.
It has 1×1.5KW/110V HY inverter.
One 3.2M Water Pump.
One 5M Water Pip.
Clamps for a 65mm spindl.
In this case, 13 ER11 Collets (1,1.5,2,2.5,3,3.5,4,4.5,5,5.5,6,6.5,7mm.
There were no instructions, but once you figure it out it’s great. Power is 110 single phase. My wire was 16 gauge. I wired the way you can see in the picture. black in R, white in S, and green to ground on the inverter next to R, which is black. Besides that, good luck to everyone. I’m still messing with the settings. I can only get 19000 RPM, even though it says it’s rated for 24000. So I’ll keep messing with the settings. Oh, and the spindle has pins 1, 2, and 3. They correspond to UVW on the board. Pin 4 is ground. So when I connect this to a TinyG, I’ll change my review.
