The machine is only used for polishing and grinding, and it has no other functions.
To prepare for using the machine, please remove the drawer-type water tank and the water pump from the water supply system before starting it. Fill the water tank with clean water until the water level reaches the highest point in the tank, then turn off the water pump and close the drawer-type water tank.
Before using the machine for the first time, please remove the sponge from the machine after it has been fully filled with water, place it back in its original position, and then begin using it as directed.
After using the machine for a period of time, it is necessary to replace the dirty water in the water tank with clean water in order to avoid the water pump from becoming blocked.
Dimensions (L*W*H): 410X270X300mm(16.1″x10.6″x11.8″), Net Weight: approximately 7 kg (410x270x300mm = 16.1″x10.6″x11.8″) (15.4LB). Power Requirements: 110V 60Hz alternating curren.
Precautions: Please avoid touching the grinding wheel or polishing wheel on the machine while it is in operation in order to avoid injury. Please do not operate the machine if the power supply is unable to meet the specifications (voltage and frequency). You must double-check the specifications of the power supply you intend to use. Do not place the machine in a hot or sunny area where it will be exposed to direct sunlight. If any liquid or material gets into the machine’s interior, please turn off the power and remove the power plug as soon as possible. The machine will not be able to be used again until it has been thoroughly inspected and repaired. Other parts of the machine can’t be assembled onto the machine, with the exception of the original parts of the machine. Don’t overload the machine, and don’t hit any parts of the machine with your hands. If the machine is not going to be used for an extended period of time, please unplug the power cord. During the operation, please ensure that the water level in the water tank is maintained and that the surface of the grinding wheel is moist. Grinding fatigue will appear after the grinding wheel has been used for an extended period of time (failing to grind in). In this case, reconditioning the wheel with the oil stone stick is recommended. While this is being done, turn on the water supply valve.
It performs admirably, despite the fact that it spins up instead of down as it should for safety.
