High-Quality Tool Set of 4″ Regular Rotary Table with an independent 70 MM 4 Jaws Chuck, Back Plate, and fixings, as well as other accessories. Bolts with a T nu.
The chuck body is made of high-grain SG cast iron, and the jaws are made of tool steel. The jaws have been hardened and ground.
In order to mount the Chuck on the Tool Steel Back Plate, T nuts are supplied with it as well as the Chuck. The back plate has been drilled in such a way that it will fit both the three and four slot tables. The backside of the Plate is equipped with a locating Spigot that allows you to center the Mounting on the Table.
It can be mounted in both the horizontal and vertical positions at the same time. The hand wheel is graduated in 10-minute increments and has the option of being reset to zero.
INSTANT DELIVERY THROUGH EXPEDITED SERVICE WITH A TRACKABLE AWB NO. TO THE UNITED STATES AND INTERNATIONALLY.
With a 70 mm 4 JAW DOG CHUCK, to be precise.
Description of a 4″ (100 mm) Rotary Table, which is intended for use with smaller milling machines (see illustration). The table has a 100 mm diameter and is graduated 360 degrees. Worm Gear Ratio is -1:36, which means that one rotation of the handle will turn the table by a full ten degrees. Cente. Height in vertical position: 2-1/16″ (50 mm approx) excluding chuck. The hand wheel is graduated in 10-minute increments and has the option of being reset to zero. It is possible to mount it in both horizontal and vertical positions. Descriptio. Chuck constructed of high-quality steel, with the body constructed of SG iron and the jaws constructed of tool steel that has been hardened and ground. The kit includes a mounting back plate as well as tee nuts and screws for installation. The back plate has been drilled in such a way that it can be used with either a three- or four-slot rotary table. In order to mount the Chuck on the Tool Steel Back Plate, T nuts are supplied with it as well as the Chuck. The back plate has been drilled in such a way that it will fit both the three and four slot tables. The backside of the Plate is equipped with a locating Spigot that allows you to center the Mounting on the Table.
In this case, it is a gift for my son’s milling machine. I was irritated by the length of time it took and the fact that the advertisement did not disclose that it was being shipped from India; this information was found on the paperwork included in the box. However, it appears to have been worth the wait, as son claims that it fits perfectly in his miller and that he absolutely loves it.
