The quality tool set includes a 4″ Regular Rotary Table with an appropriate Tailstock, as well as a 70 mm 4 Jaws Independent Chuck with Back Plate and mounting hardware. Bolts with a T nu.
The chuck body is made of high-grain SG cast iron, and the jaws are made of tool steel. The jaws have been hardened and ground.
In order to mount the Chuck on the Tool Steel Back Plate, T nuts are supplied with it as well as the Chuck. The back plate has been drilled in such a way that it will fit both the three and four slot tables. The backside of the Plate is equipped with a locating Spigot that allows you to center the Mounting on the Table.
It can be mounted in both the horizontal and vertical positions at the same time. The hand wheel is graduated in 10-minute increments and has the option of being reset to zero.
INSTANT DELIVERY THROUGH EXPEDITED SERVICE WITH A TRACKABLE AWB NO. TO THE UNITED STATES AND INTERNATIONALLY.
Style:WITH 4 JAWS INDEPENDENT CHUCK AND 70 MM LENGT.
The 4″ (100 mm) Rotary Table is described in detail. Designed for milling machines with a smaller footprint. 100 mm is the diameter of the table. The table is graduated in all directions. Worm Gear Ratio is -1:36, which means that one rotation of the handle will turn the table by a full ten degrees. Cente. In the vertical position, the height is approximately 2-1/16″ (50 mm), excluding the chuck. The hand wheel is graduated in 10-minute increments and has the option of being reset to zero. It is possible to mount it in both horizontal and vertical positions. The kit includes a small 70 mm 4 jaws Independent Chuck, which is constructed of high-quality materials: the body is made of SG iron, and the jaws are made of tool steel that has been hardened and ground. The kit includes a mounting back plate as well as tee nuts and screws for installation. The back plate has been drilled in such a way that it can be used with either a three- or four-slot rotary table. In order to mount the Chuck on the Tool Steel Back Plate, T nuts are supplied with it as well as the Chuck. The back plate has been drilled in such a way that it will fit both the three and four slot tables. The backside of the Plate is equipped with a locating Spigot that allows you to center the Mounting on the Table.
I haven’t put it to use yet. It arrived yesterday, and it was extremely fast coming from India. We’ll have to make an adapter plate to mount it because it’s a little too large for my table. It appears to be very well made, and it is also very cute to look at. Please accept my sincere gratitude for this. Joe
