Adjustment of the Rack & Pinion Tabl.
The manual disc brake is called that.
With a lot of space to work, this is .
a paddle switch that can be turned on and turned of.
You can buy a Steel Disc Plate on Amazon.co.
The RIKON 51-200 12-inch Benchtop Disc Sander is great for sanding small pieces of wood, metal, and even plastic. It has a 12-inch disc that spins at 1,720 RPM for fast and efficient sanding. With a strong 1/2-horsepower motor and a cast iron work table that can tilt in both directions, this benchtop sander lets you sand at any angle. It has a sturdy base and a powerful motor.
The Cast Iron Base Makes It More Stable.
An iron base helps keep the RIKON Benchtop Disk Sander in place while it is being used. Keep the sander from moving while it is being used by putting rubber feet on the bottom of it. You can clamp the disc sander to your workbench for a short time, or you can use the mounting holes to make it more secure.
Tilting Work Table for Flexible Us.
To bevel-sand with the cast iron tilting work table is simple. With a positive and negative tilt option, the large, 17-1/8-inch by 6-1/2-inch work table can hold your work piece in any position you need it to stay. It’s easy to move and lock the table in place with a table lock knob. The table stops at 0, 22.5, and 45 degrees in either direction.
Work: Heavy-Duty Miter Gauge Guide.
The RIKON Benchtop Disc Sander comes with a heavy-duty miter gauge that helps you keep your work steady as you sand the end surface of small pieces.
Disc brakes are quickly stopped when you use a manual brake.
In order to quickly stop the disc from spinning, you can apply pressure to the manual brake lever, which is located at the top of the disc. The switch has now been turned off.
For Safe and Legal Use: Turn the Switch Key to the Right.
To make sure that the RIKON Benchtop Sander is used safely and correctly, there’s a switch key that you can use. Insert the key into the switch to turn it on and then take it out when you’re done to keep it from being used by accident or by someone else.
There are features that keep the air clean.
There are fan fins on the disc that goes on this bench top sander to help move the dust away from the work area and out of the dust port, which makes sanding cleaner. A standard shop vacuum can be connected to the dust port with a 2-1/4-inch I.D. or 2-1/2-inch O.D. connector. This allows you to get the most out of your vacuum.
When you buy a car, there’.
You can get your money back if you don’t like it for two years. This is the RIKON 51-200 12-inch Benchtop Disc Sander.
What’s inside the box.
It comes with a miter gauge, a disc brake, an 80-grit abrasive disc, screws to mount it, a dust port, and a manual.
There is a Manufacturer.
12-Inch Disc Sander with Brake.
So far, things are going well. The disc moves smoothly, with no run off, and the brakes are very useful. There is no use for the “auto set angle” device on the table because it has too much play. It is still easy to adjust and set up the table without the device.
