If the tracking screw is worn, it will not hold the belt on. A build up of sawdust on the rollers will cause the belt to track erratically. You should also make sure to use a belt specifically for your sander and that you are using the correct belt for the job you are working on.
AUTO-TRACK SYSTEM. Your sander features the automatic belt control. s. ystem which keeps the belt running in the. “Coat” belt and has a. white colored.
skil belt sander 7313 troubleshooting Related Question:
Why does my belt sander keeps breaking belts?
Heat, humidity, and age can contribute to belt seam failures, but they’re not the only causes. Check that your belts are turning in the direction indicated on the inside face. When not using your sander, release the tension on the belt.
What size belt does a Skil belt sander take?
Skil Model 3375 Specifications RPM: 0-3,450/Min. Disc Size: 6 in. Belt Size: 4 in. x 36 in.
Can sanding belts be repaired?
You can also mend or make abrasive belts by this DIY method: Obtain some bias binding tape from a fabric store, or you can make your own. Then use CA adhesive to bind the bias binding tape to the cleaned edges of the sanding belt you want to make or repair. I have done this many times, and it works fine.
How many amps is a belt sander?
Belt sander motors range between 5 amps to 10 amps. If you plan on using your belt sander on softwoods, you don’t need that many amps. But, if you want to use it on a piece of maple, it should pack more power. Still, even a 5-amp belt sander is a very powerful tool.
What kind of tape is used on sanding belts?
Apply the Scotch 8959 tape by using a small piece of swimming pool noodle or other firm foam/rubber like a squeegee pressing firmly and leaving overlap on both ends, make sure there are no air bubbles and the tape is perfectly flat covering both splice ends equally.
What type of glue is used to make sanding belts?
Lay one end of the belt, grit-side down, on the bench; then apply cyanoacrylate glue to the end of the belt. Lay half of the bias tape’s width on the glue, place waxed paper over the tape, and use a weight to press down on it for about 30 seconds, or until the glue sets.
Can you cut sanding belts?
You can cut sanding strips from sanding rolls or sanding belts. Cutting from sanding rolls is the more ideal solution.
Should you push down on a belt sander?
You do not have to push down on the sander. Pull the sander backward letting the weight and sharpness of the belt cut the surface. Don’t pull back and then tip the sander off the edge or you’ll cut off too much wood and need to build it back up with putty.
How tight should a belt sander be?
In basic terms, the amount of tension on the coated abrasive belt should be just enough to keep the belt from slipping on the drive wheel, and to keep the belt from tracking off the wood working machine.
How should the belt sander be placed when setting it down after the sanding?
6. When finished sanding lift the belt sander off the material and then release the Off/On switch. 7. Lay the belt sander on its side when setting the tool down.