The main material is nylon fiber, and it’s very abrasive. It comes with one polishing wheel.
This is a polishing wheel. It weighs 99g.
180 Grit; Gray is the main color.
This is the overall size: 150 x 25mm/ 6″ x 1″ (D*T.
The inner diameter of the hole is 16mm/0.63.
It has a diameter of 150 millimeters and a thickness of 25 millimeters, and a grit of 180 on it. Ideal for grinding, polishing, and buffing metal, jewelry, and more. In aerospace, plant maintenance, foundry, automotive, metal fabrication, and shipyards, this tool is used a lot.
It took me a while to figure out how to put this on my 1/2″ shaft 6″ grinder. I think the hole is about 15mm, which is closer to 5/8″ than to 1/2″. I used a plastic sleeve from an old wheel that I had to make up for the difference in size. It runs straight and polishes stainless steel very well.
My job is to make golf club hat racks for sale. I have to clean each club. Most of the time, you can use a wire wheel to get the job done. When you want a nice shine, this does the job.
A 3M wheel I used for years was almost worn down to the nub. When I looked at the prices, I decided to try this one out. I don’t think this will last as long as the 3M. There is a 3M that is more dense, and the one on my other grinder has been there for 15 years. However, if you’re just going to clean the heads of your golf clubs, this is a much more cost-effective choice.
Pleased so far and would buy again.
It took a long time for the wheel to wear out after I used it to clean and polish golf club heads for my golf club hat racks. A lot of people say that it gets worse as the thing shrinks. You should wear a mask.
