Test 1 – New BladeWe purchased a MK-415 high quality porcelain blade and the saw cut relatively straight for a short period of time. “Test 3 – Pencil Attached to Blade Guard In the third test, I attached a construction pencil to the blade guard with a clamp to again take the blade out of the equation. Without much problem, I was able to produce a straight line on a 24” tile by adjusting the backstop. Once a blade is added to the equation, we are back to square one and not cutting straight.
Re: Ridgid WTS2000L Tile saw won’t cut straight. Holding from the top, back, side, applying significant pressure from all sides, applying very little pressure to all sides, pushing from various places, etc. The blade doesn’t look warped, but I will measure it.
This helped a little bit but the cut was still not straight or clean. “I’m having a hard time making straight cuts because the guide is too small for my tile. I’ve been trying to feed the tile without the guide but I’m finding this doesn’t make very straight cuts.
wet tile cutter not cutting straight Related Question:
Why is my wet saw cutting crooked?
this can be due to a couple of factors.from to little water causing the blade to heat up and also pulling the saw through too quickly can cause stress and the blade to wander off line… If you can rule these out then you need to check if the back guide rail is square..
Why won’t my tile cutters cut straight?
Try double scoring the end that is not braking correctly. you could just be missing some pressure on the scoring action. Try slowly breaking the tile with smaller push down actions with the breaker on the tile and slowly move up the tile doing the same instead of one swift snapping action.
What causes tile to chip when cutting?
If a tile chips, it is generally not a manufacturing fault but is the cause of one of the following accidents against the tile itself: Dropping a heavy or hard object onto the ceramic or porcelain tile. This may cause the surface to crack or chip. Walking or dragging metal heels or hammering nails onto the tile.
Why is my wet saw sparking?
The sparks are the little pieces of tile turned to tiny shards and red hot from the cutting tool. This is normal. Wear goggles and protect your work surfaces so you don’t burn them.
Why is my tile saw binding?
Because the saw is forcing a groove into the tile there is a huge amount of friction caused. Friction generates heat, and if the heat is allowed to build up it can cause the saw to bind up and stop cutting.
Can you cut tiles upsidedown?
Regardless of the kind of tile you’re cutting, the best method is to cut with the front of the tile facing up. The front is the side that will be exposed once you lay the tile. This method ensures the smoothest finished edge on the tile with the least amount of chipping.
Can I put a wood blade on my tile saw?
Can a Wet Tile Saw Cut Wood? Though a wet tile saw may resemble a table saw, it is not designed to cut through wood. It is equipped with a diamond-edged, carbide blade that is different from that of a table saw. As well, this tool spins the blade in the opposite direction of a table saw.
Can you use a wet saw to cut porcelain tile?
Unfortunately, wet saws can also chip the surface of porcelain tiles, so many tile installers use a couple of tricks to help ensure a cleaner cut. You’ll need a wet saw with an adjustable blade to reap the full benefits, but you can still reduce the likelihood of chipped porcelain with a standard-depth saw.