The fuel line and purge line both pass through the wall of the tank and need to be pulled out with some effort from inside the tank through the fuel fill port. Don’t pull all the way through the fuel fill, just enough to install the new fuel line fitting in the return purge line and the new weighted filter on the fuel line and pull the lines back inside the tank. The fuel routes from that filtered line into the carb, then out of the carb to the purge bulb suction side, then out to the return line in the tank with the fitting end.
Kevin I have done a few of these and I always use Tygon 4040-A. It is little bit of a tight fit thru the hole but if you cut a long taper on the end and get it fished thru then it will pull thru easily. On the other end where the fuel filter is attached I spread it with a small pair of needle nose pliers to get the fuel filter on.
what size is poulan chainsaw fuel line Related Question:
What size fuel lines does Poulan chainsaw use?
Poulan Pro Fuel Line Kit No. Comes with a large 3/16″ OD by 3/32″ ID 2 feet long, small 9/64″ OD by 5/64″ ID 2 feet long. Also comes with the fuel line fitting connector.
What size is a Poulan 2150?
5-Pack 16″ Semi Chisel Saw Chain for Poulan 2150 Chainsaws – (16 inch, 3/8″ Low Profile Pitch, 0.050″ Gauge, 56 Drive Links, CSC-S56)
What size is Husqvarna fuel line?
At about 24” in length, this line is usually long enough to do more than just one fuel system and works on most, but not all Husqvarna (brand names also included are Poulan, Craftsman, and Weedeater) 2-cycle equipment. This is a 1/8 in. fuel line for a Husqvarna 142, very hard to find.
Can you run a chainsaw without a fuel filter?
While it’s possible to run your chainsaw without a fuel filter, but this is not recommended. When a fuel filter is clogged, it can cause considerable damage to the engine and leave your chainsaw unusable.
What size fuel line does a Craftsman chainsaw use?
Fuel Line (Small)- 9/64 (. 140) inch OD – (. 080) inch ID, W/ Installation instructions.
What line is primer bulb?
The (clear) fuel intake line runs from the top of the carburetor (straight nipple) and goes to the short post on the back of the primer bulb. The return line (blue) comes from the long post on the back of the primer bulb and goes into the bottom of the fuel tank.
What is the oil to gas ratio for a Poulan chainsaw?
Q: How do I mix gas and oil? A: Mix 3.2 ounces of Poulan 2-cycle air cooled engine oil to one gallon of fresh unleaded gasoline to obtain the recommended 40:1 fuel to oil ratio. Over a period of time oil will separate from gasoline.
How do you clean a chainsaw fuel filter?
Brush the air filter gently with a soft brush or wash it in warm soapy water then dry it. Do not use compressed air to clean it – compressed air can blow holes in the filter, allowing dust and debris into your carburetor.
Do carbureted engines have fuel filters?
With carburetors, the fuel filter can be found under the hood by following the fuel line backward from the carb. Usually it’s a small cylindrical filter that connects to the fuel line on either end.