In comparison, a Type 1 cutting wheel has a flat profile and increased cutting surface, allowing the operator to complete more cuts per wheel. Two specific applications for a Type 27 cutting wheel are flush cutting and rip cutting. No matter what type and style of cutting wheel an operator selects, understanding how that product is designed to be used and following some best practices for technique can help extend operator safety and product life, as well as maximize performance and results.
For the best results, ensure that the angle grinder stays tilted at a 90 degrees angle to the surface you’re cutting. You can also try to use a sliding/rocking motion still in the angle grinder cutting direction – move the cutting wheel into then through your workpiece instead of straight down. In addition to maintaining the correct angle grinder cutting direction all through, there are several good practices you should follow to maximize the performance of your grinder.
You can buy very inexpensive angle grinder tool, but for frequent use or for demanding jobs like cutting stucco or cement, I’d recommend spending a little more for a grinder with a more powerful motor. Outfitted with a grinding wheel, an angle grinder is a great tool for restoring edges on rough-and-tumble tools like hoes, shovels and ice scrapers or for the initial grinding of axes, hatchets and lawn mower blades. Finally, with the grinder off, rest the grinding wheel against the blade and adjust the angle of the grinder to match the blade’s bevel.
Zzzzzzzzzzzzzzzzzz!…………poor wind up!! No indication on the machine itself as to disc rotation and no indication on the cutting disc. ” A wise man is wise enough to know there are men wiser than himself “.
Hi. I have an el cheapo 9 inch angle grinder that I bought years ago. The brand is Kinzo and it has a reversible handle “Showering high velocity muck and sparks in all directions and very very noisy.” All part of the fun. My main concern is a disc fragmenting, or setting fire to my house, but so far no problem.
If you hold the angle grinder as if you are cutting off a horizontal bar, the front of the wheel is moving downwards, the sparks are going away from you. I fitted a jacobs chuck to an angle grinder so that I could drive the small diameter grinding points and bobs up to about a inch in diameter,does not work very well ,the chuck holds the small wire brushes tight ,the rattle effect on the sides of the grinding points soon loosens the chuck,,I was then given a windy drill with a collet which takes 1/4 and 6mm grinding points ,I soon gave this up as my compressor could not keep up with the drill,so the collet was adapted to fit the angle grinder and has worked well for the last 15 years,I used a 4 inch angle grinder as these run slightly faster than 4 1/2 inch grinders,it gets a a lot of usage when removing rust and debris from tight corners and crevices in old stationary engines. Angle grinder rotates in opposite direction as thread pitch.
We got our Pro team together to give you some tips on how to use an angle grinder from basics to some advanced techniques and shortcuts. Additional Pro Tips on How to Use an Angle GrinderBefore applying the grinder to the work surface, allow the tool to reach full speed. If you’ve got any tips or tricks on how to use an angle grinder, feel free to leave your input in the comments section below!
