If a chainsaw cuts at an angle rather than cutting straight, then the problem most certainly lies in the guide bar and chain assembly. Adjust the chainsaw bar: If possible, adjust your chainsaw bar on a bench before continuing. Use a bar cleaner handle: A bar cleaner hook tool removes debris stuck in the bar’s rails.
Your chain will have links on both sides of the chain. As I mentioned earlier, the chain is most likely the root cause of your problem, but if that’s not it, then it could also be your chainsaw bar. Use your gauge tool to clean the oil hole on both sides of the bar, to keep your chain running smoothly.
Most of the time when a saw won’t cut straight, it’s caused by a problem with the saw chain. Most of the time, when a saw won’t cut straight, the chain is the culprit. Since a saw chain is a “Team” of cutter teeth, the cut will pull in the direction of the side whose cutter teeth take the biggest bites.
I’ve also seen chains that were brend new at the start of the day, cutting cut circles by the end of the day due to someone hitting dirt/sand/rocks or pushing the chain way longer then they should have. If the chain is damaged like it would be if its cutting arcs take the chain to a saw shop to get the chain sharpened. Bottom line, if sharpened at the right angles, and if sharp……it will cut straight.
why chainsaw not cutting straight Related Question:
Why is my chainsaw cutting at an angle?
One major reason a chainsaw curves to either the right or left during a cut is that it was unevenly sharpened. The unequal teeth of the chain cause it to take a different-sized bite into the wood. What is this? The uneven sharpness of the chain is mainly due to manual sharpening, especially with the use of a file.
Why does my saw not cut straight?
The primary reason why a miter saw might not cut straight is an inability to clamp the material down. The machine is designed to pull the material towards the blade during each cut, and if there’s a malfunction in this process, it might result in inaccurate cuts. Other reasons are: damaged blade.
How do you tension a chainsaw blade?
Loosen the bar nuts on the side of the chainsaw guide bar. Insert a screwdriver or chainsaw scrench into the Intenz slot of the guide bar. Turn the screwdriver or scrench clockwise to move the guide bar forward to proper chain tension. Perform a “snap” test to ensure proper saw chain tension.
Why does my chainsaw chain keep coming loose?
Chain Not Set Properly One of the most common reasons why your chain might be coming loose is because it was not set properly. When you go through the steps to tension your chain, you need to finish those steps by setting the tension so it won’t change as you work your saw.
Why is my chainsaw blade smoking?
This most commonly is a result of a dull chain and exerting to much pressure on the bar and chain trying to make the chain saw cut. This could also be either a lack of bar and chain oil ( tank empty, restricted oiler hole ) or an inferior type of oil that is being slung off the chain and not lubricating.
When should you throw away a chainsaw chain?
The chainsaw pulls in one direction, which results in a crooked finish. Blunt cutting teeth on one side or uneven teeth lengths usually cause this. The teeth has hit rocks or dirt and broken. If you notice the tops of the teeth are missing you will need to replace the chain.
Can you over tighten a chainsaw chain?
There is a tension screw located near the base of the bar on the chainsaw. To tighten the chain, turn it clockwise, and to loosen turn it counterclockwise. Don’t over-tighten the chain as this could cause it to break.
What can I use for straight edge?
If there are no markings, it is simply a straight edge. A ruler can be used for measuring and marking straight lines. A straight edge will not help you measure, but most are built more durably than rulers, making them a superior tool for marking straight lines. In most cases, rulers can function as a straight edge.
What wood is straight?
Select pine boards These pine boards are the cream of the crop. Typically they are very straight (but always check your lumber before buying it) and have few imperfections.