Your gas chainsaw engine starts, but the chain won’t move. Check out the ‘Removing/Replacing the Guide Bar and Chain’ section in your gas chainsaw manual. A dirty air filter can affect your gas chainsaw’s ability to cut.
Take the guess work out of your repairs with our Fix app. Tap to download and it’s as easy as snapping a photo to find repair parts guaranteed to fit.
why isn’t the chain on my chainsaw moving Related Question:
Why did my chainsaw blade stop spinning?
If the chain is too tight, the blade may not spin when the throttle is engaged, which can cause damage to the clutch or other associated parts. Keep in mind that the tension of the chain will change with heat. As the chainsaw is used and the chain heats up, it will become loose.
Why does my chainsaw chain keep jamming?
Here are our explanations! Indeed, whether it is a chainsaw electric ou thermal, it is the teeth of its links that come into direct contact with the wood and the materials to be cut. As a result, dirt, wear on the guide or links and even the motor can be the cause of jamming.
Why is my Husqvarna chainsaw chain not turning?
Common solutions for: Husqvarna Chainsaw chain not turning Make sure that the stop lever is disengaged. If the stop lever is engaged, the chain won’t turn. If the clutch pads are worn out, replace the clutch assembly. The clutch pads engage the clutch drum to allow the chain to rotate.
How does a chainsaw chain catcher work?
The chain catcher helps prevent the chain being thrown back towards the user, if the chain breaks or becomes derailed. The catcher catches the chain when it derails downwards and shortens it.
Can a chainsaw without a chain hurt you?
Can You Run a Chainsaw without the Chain? You can run a chainsaw without a chain but try to do that just for a few minutes. I wouldn’t advise you to run a chainsaw without a chain for more than a few minutes. If you are not careful, you can overheat the engine and increase the wear and tear.
Can you over tighten a chainsaw chain?
There is a tension screw located near the base of the bar on the chainsaw. To tighten the chain, turn it clockwise, and to loosen turn it counterclockwise. Don’t over-tighten the chain as this could cause it to break.
How do you tell when a chainsaw chain is worn out?
The chainsaw pulls in one direction, which results in a crooked finish. Blunt cutting teeth on one side or uneven teeth lengths usually cause this. The teeth has hit rocks or dirt and broken. If you notice the tops of the teeth are missing you will need to replace the chain.
How do I know if my chainsaw chain is too loose?
The chainsaw chain should feel snug but still pull freely. Finally, perform a “snap” test to ensure proper saw chain tension. Simply pull the chain on the underside of the guide bar down so one or two drive links are out of the guide bar rails and release it. The chain should snap directly into position.
How does a chainsaw throttle work?
The carb is operating “normally” at full throttle. In this case, the throttle plate is parallel to the length of the tube, allowing maximum air to flow through the carb. The air flow creates a nice vacuum in the venturi, and this vacuum draws in a metered amount of fuel through the jet.
What does a spark arrestor do on a chainsaw?
The spark arrestor on your chainsaw prevents dangerous hot sparks from igniting fires while you’re working. If the arrestor is clogged or dirty, however, it will also prevent exhaust from leaving the motor, which can prevent it from running.
What is throttle interlock?
The throttle interlock trigger prevents the throttle from engaging accidentally. If the interlock is not depressed, the throttle cannot engage. The feller must have his left hand firmly on the handle to depress the interlock and trigger at the same time.