Efficient Work: It has double torque of 0.15/3Nm, which is enough power for your electronics repair work. Smart phones, RC drones, a game controller, and so on are some of the things you can use.
High Speed: The high speed of 200 RPM, which is the standard for precision screwdrivers in the world. You need to find the right mix of high speed and protection for precision screws.
With a pen shape and aluminum shell, this electric screwdriver comes with 20 screw bits in accordance with international standards. It has a slim aluminum alloy body with a pen shape design that is easy to use for both men and women.
With 3 LED lights, it’s easier to do the repair work with our Screwdriver Electric Cordless.
Our electric screwdriver with a lithium-ion battery that can be charged in 40 minutes can work for 8 hours at a time; it can go without being used for 2 hours, and it can last for 180 days. You can also use dual power, which makes your work much easier.
Pros.
It looks good.
Worked well.
It takes a long time for the battery to ru.
The built-in light was nice.
Felt good to hold.
Torque was okay. When it was used to screw PC parts together, it did its job.
Cons.
Made of aluminum that was very thin, which made it look cheap when you looked at it close up. It rolled off my coffee table and fell one and a half feet to the floor. Dents had formed on both sides where a cap slides on. This made it impossible to put the cap back on again, making it impossible to write with the pen.
There was a sense that it was not very well made. There were edges of cheap aluminum that you could feel when you pressed down on a button. if the whole pen didn’t just feel cheap.
The built-in light was nice, but don’t expect to use it to actually see into tight spaces BEFORE you try to align the bit to the screw because the light only works when you hold down the torque button. This means that you can’t see where you’re putting the bit before the bit starts spinning, which isn’t a good use for a built-in light.
It was good for my electronics needs, but if you over tighten or try to loosen a screw that is too tight, the motor grinds and gives off an even more cheap feel. Having to go back and forth between two tools was a pain. My PC was built with this tool. I put it away for a few days, and when I took it out to use again, the torque just stopped and it wouldn’t work again. Motor was running, but the bit wasn’t moving. No doubt I had to return it.
In general, I think it will be good for some light electronic work, but I don’t think I’d use it at all. There are better products out there that don’t look or feel as cheap as this one does. To buy it is up to you. If you like it, that’s great. It’s not for me.
