That’s always debatable, so we have the brand new DeWalt DCS570 20V Max Circular Saw to see what it can do in the 7-1/4-inch cordless class. As a bare tool, the DeWalt 20V Max Brushless Circular Saw rolls in at $159. That’s an excellent price for the performance you get and easily one of the best values currently available. DeWalt 20V Max Brushless Circular Saw Manufacturer’s FeaturesBrushless motor provides 5,200 RPM maintaining speed under load.7-1/4-in blade provides 2-9/16-in cutting capacity at 90°.57° bevel capacity with positive stops at 45 and 22.5 provides increased versatility.
how to use dewalt xr circular saw Related Question:
What battery should I use for Dewalt circular saw?
A: I used 6 Amp battery with the Dewalt Cordless Saw. It’s heavy, but will last much longer the than 2 or 3 Amp batteries. Helpful? A: A 3.0 AH battery or higher is recommended.
Can you adjust the depth of a circular saw?
A circular saw has a depth adjustment lever or knob that releases or loosens to allow for adjustment of the saw’s bottom plate, often called the “shoe.” First unplug your saw, then disengage this lever so that you can freely adjust the cutting depth by raising or lowering the bottom plate.
How shallow can a circular saw cut?
Circular saws turn corners about as well as a freight train, and standard models will cut only about 2 1/2 inches deep. There are ways around the shallow cut—for example, you can flip over a 4×4 and cut from two sides—but the curve limitation has no work-arounds.
How do you adjust angles on a circular saw?
Mark the width (cut line) at which you want to make the bevel cut using pencil and speed square. Fix a straight edge such that the blade aligns with the cut line. Set a 45-degree bevel angle on the circular saw. Set the blade depth such that the blade makes a through cut in the wood.
Can you bevel with a circular saw?
Circular saws commonly include an adjustment that allows you to set the blade angle anywhere from zero to 45 degrees. Using this feature, you can cut a bevel along the length of a board and a miter across the end.
Why is my circular saw kicking back?
Overheating a saw blade can cause it to warp and result in a kickback. Buildup of sap on the blades, insufficient set, dullness and unguided cuts, can all cause an overheated blade and kickback. Never set a blade deeper than is required to cut the work piece 1/8 in. to 1/4 in.
How do you cut straight with a circular saw without a guide?
To ensure a straight cut, press the saw firmly against the straightedge as you push it along. Clamp a perfectly straight board or metal straightedge to a sheet of plywood to make cabinet-quality straight cuts.
Why is my circular saw burning the wood?
Pushing the stock through the saw too slowly is a common cause of saw blade burn. Sometimes a blade that feels dull might only be dirty. If wood pitch resins build up behind the teeth of the blade, the cutting speed will slow down, increasing the chances for burns. Commercial blade cleaners are sold for this purpose.
Which cut is when you cut a straight 90 degree across the grain?
A crosscut is a straight, 90-degree cut that cuts across the grain of the wood. Usually, that means turning long boards into shorter ones. On a table saw, you will usually use a miter gauge to make crosscuts. It’s the most basic cut you can make.
Do I need a workbench to use a circular saw?
To get the most out of your saw, you’ll need a couple of pieces of equipment. For a start, we recommend a good work table or bench for supporting your material. There’s other ways of brace wood for cutting, but a workbench is by far the simplest and most straight forward method.
