how to use erbauer circular saw Related Question:
How do you unlock Ozito drop saw?
1 To unlock the saw head, press down slightly on the handle and then pull and rotate the head locking pin 90 degrees. 2 To lock the head down, press the head down and the pull and rotate the head locking pin 90 degrees. To switch the worklight on, press the worklight switch up into the on position.
Why won’t my miter saw lift up?
Depending on the model, it may require twisting, but typically is only an inward, outward movement of the pin. The blade should lift up automatically when the pin is released. The guard should cover the blade as it lifts. If it doesn’t, it’s likely dirty or stuck and should be cleaned to move freely with the blade.
Which way should a blade be installed on a circular saw?
When installing a new blade, make sure the teeth are pointing downward to enable a clean cut through the workpiece. Upward-facing teeth can cause a severe injury to the operator.
Why is my circular saw blade loose?
Bearings and washers are mainly responsible for holding a saw’s shaft in place. However, wobbles and misalignments may loosen the blade. This can cause problems while cutting. Moreover, the bolt of the circular saw may wear out after regular use.
Why does my circular saw burn the wood?
A dull blade will make it hard to cut quickly, and the slower the feed rate of the saw, the more friction against the wood and the greater the likelihood of scorch marks. Pushing the stock through the saw too slowly is a common cause of saw blade burn. Sometimes a blade that feels dull might only be dirty.
Why does my circular saw kickback at the end of a cut?
Overheating a saw blade can cause it to warp and result in a kickback. Buildup of sap on the blades, insufficient set, dullness and unguided cuts, can all cause an overheated blade and kickback. Never set a blade deeper than is required to cut the work piece 1/8 in. to 1/4 in.
How do you cut straight with a circular saw without a guide?
To ensure a straight cut, press the saw firmly against the straightedge as you push it along. Clamp a perfectly straight board or metal straightedge to a sheet of plywood to make cabinet-quality straight cuts.
How do you use a circular saw without a table?
Fit your circular saw with an edge guide. Set the depth of the blade accurately enough for it to go through the wood and not cut under the surface. Place the guide on base of the circular saw lines and markings you made earlier on the wood. Ensure that the saw is free to move, and the power cord is not entangled.
How much does a miter saw cost?
A basic compound miter saw starts at $100, while miter saws with sliding blades start at $125. Dual-bevel miter saws start at $200, and professional-level miter saws with special features can cost as much as $800.
